
Take your Window Motor and plug it into the wiring harness on the car WITHOUT THE WINDOW REGULATOR ATTACHED.
Using the master switch, pull all the way up and allow the motor to spin for approximately 30 turns.
As the diagram shows, ensure the Window Regulator slider is in the correct position. This is the required position to bolt the glass on and to initiate the learning procedure.
Assemble the Window Motor to the Window Regulator and bolt it back into the door.
The Window Motor MUST NOT be powered in any direction at this stage.
Secure the glass to the Window Regulator and plug in the Window Motor loom.
Using the master switch, pull all the way in the UP DIRECTION ONLY. Continue holding up until the window is fully closed and continue to HOLD for 1 or 2 seconds.
You can now power the window motor in the auto down cycle.
To check that you have set the memory correctly, power the window in the AUTO UP cycle. The glass should power to the closed position and stop there.